Automatic Doors and Gates Loop Detector Relay Output Vehicle Loop Detector Single Channel 12V 24VDC
Automatic Doors and Gates Loop Detector Senses With Low Voltage Two Relay Output
JUTAI single channel loop detector operates on the principle of inductance, it operates through the detection loop at a frequency between 20 to 2000 uH, to create an electromagnetic field. Jutai is committed to the development of the detector sense of the ground, each accessory is carefully tested and aging, pre-shipment testing to ensure that our customers are assured.
Two Relay Output Single Channel Loop Detectors Introduction
JUTAI single channel automatic doors and gates loop detector is an intelligent product designed to accommodate numerous applications such as vehicle counting, toll systems, parking lot, traffic control, and traffic analysis. LD-106 can be adjusted intelligently to any environments and virtually eliminating false detection. On the front panel, the frequency can be altered to completely eliminate any crosstalk. In the event of an intermittent failure or automatic recovery of the fault loop, the detector will resume normal operation without the need to manually reset the detector. There are three colors LED status indicators, representing "detection", "power" and "loop failure".
Automatic Doors and Gates Loop Detector Features
LD-106 has two separate output relays. Output A is presence output which is can be extended for 0, 2, 5, 8, 10, 15, 20 or 30 seconds, programmable with external DIP switches. Output B, programmable with external DIP switches, provides presence, pulse on entry, pulse on exit, or failed output. Any vehicle with a speed of no more than 120km/h will be detected. It also consists of 11-pin Amphenol rear connectors.
Automatic Doors and Gates Loop Detector Specifications
|Frequency range||Four steps switch selectable 20-80KHz|
|Sensitivity||16 way selectable /Highest 0.010% DL/L / Lowest 2.56% DL/L|
|Operating temperature||-40℃ to +70℃ / (-111℉ to +158℉)|
|Relative humidity||Up to 95% relative humidity without condensation|
Automatic drift compensation
|Output mode||Presence Relay/Fault Relay output|
|Visual Indications||Power LED-Red / Channel LED-Green|
|Integral Fault Relay||provide an output in the event of a loop fault condition.|
Automatic Doors & Gates Loop Detector position and installation
- Install the detector in a weatherproof housing.
- The detector should be as close to the sensing loop as possible.
- The detector should always be installed away from strong magnetic fields.
- Avoid running high voltage wires near the loop detectors.
- Do not install the detector on vibrating objects.
- When the control box is installed within 10 meters of the loop, normal wires can be used to connect the control box to the loop. More than 10 meters requires the use of a 2 core shielded cable. Do not exceed 30 meters distance between the control box and loop.
DHL, UPS, Fedex, TNT ,EMS, DTDC etc.
We will choose the safe and cheapest way for you to reduce your cost.
Economic shipping way: by sea, by air transport.
For mass order, shipping by sea or by air transport will be a good choice
We will provide the after-sale service by e-mail, skype, WhatsApp, trade manager, telephone, QQ and wechat etc if you need any assistance from us after receiving the order.
Any inquiry about our automatic doors and gates loop detector, please feel free to contact us, we believe that you will be satisfied with our products quality. https://www.jutaigateaccess.com/